RADIATOR & COMPONENTS. 3. 6 liter.. 2014 Volkswagen Passat 3.6L V6 M/T SE Sedan

3.6 LITER.

3.6 LITER. Radiator upper seal.

3.6 LITER. Radiator lower seal.

Left.3.6 LITER. Right.3.6 LITER. Auxiliary Radiator. Intercooler Bracket. Isolates the Intercooler from shock and viBration at it's mounting points. Primary Radiator. Radiator Insulator. Radiator Mount Bracket.

Left.3.6 LITER. Right.3.6 LITER. Upper mount bolt. A Screw that is used to secure the Floor Pan Heat Shield to it's Mounting point. A Screw that is used to secure the Side Marker Lamp to it's Mounting point. A Screw which secures the turn signal Lamp housing to it's Mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc) on one end used to secure the Supercharger Intercooler to it's Mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Radiator Support Air Duct to it's Mounting point. Bolt that secures the bumper cover. Bumper Cover Screw. Bumper Cover Support Rail Screw. Bumper Impact Bar Bolt. Fender Liner Screw. Fog Light Screw. HeadLight Mounting Bolt. Radiator Mount Bolt. Radiator Support Air Deflector Screw. Radiator Support Air Duct Screw. Radiator Support Splash Shield Bolt. Radiator Support Splash Shield Screw. Rocker Panel Molding Screw. Running Board Screw. Spoiler Screw.

Left.3.6 LITER. Right.3.6 LITER. Auxiliary Radiator. Center Radiator. Inverter Cooler Insulator. Isolates the InterCooler from shock and vibration at it's Mounting points. Primary Radiator. Radiator Insulator. Radiator Mount Bracket.

3.6 LITER. Reservoir.

3.6 LITER. Reservoir bolt. A Screw that is used to secure the Engine Coolant Expansion Tank to its mounting point. Engine Coolant Reservoir Bolt. Recovery Tank.

3.6 LITER. A Clip which helps secure the Radio Speaker to it's mounting point. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Decklid Handle. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Door Belt Molding. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Door Handle Bezel. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Engine Coolant ExPansion Tank. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Hood Release Cable. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Hood Release Handle. Back Glass Reveal Molding Nut. Back Glass Sunshade Nut. Body D-Pillar Trim Panel Clip. Center High Mount Stop Light Clip. Center High Mount Stop Light Nut. Console Nut. Deck Lid Trim Nut. Fender Liner Nut. Grommet through which a portion of the ExPansion Tank fits when mounted to vehicle. HeadLight Bezel Nut. Kick Panel Trim Nut. Liftgate Trim Cover Nut. Liftgate Trim Nut. Liftgate Trim Panel Clip. Liftgate Trim Scuff Plate Nut. Nut to secure bumper Cover. Nut used to mount HeadLight. Nut used to secure the Speaker. Quarter Panel Trim Panel Nut. Seat Belt Lap and Shoulder Belt Nut. Tie Down Hook Nut. Trunk Trim Panel Nut. Included with: Lower Trim Panel, Trunk lid Trim.

3.6 LITER. Reservoir cap seal. 28.5 x 3.8mm. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spring that prevents fluid from leaking at the Engine Coolant Expansion Tank Cap. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spring that prevents fluid from leaking at the Engine Coolant Expansion Tank Hose. A component which provides a sealing surface at the Engine Coolant Overflow Reservoir Cap. Engine Coolant Reservoir Seal. O-Ring. Part serviced with reservoir cap. Seal used on the Radiator. Gasket. Overflow Hose. Pipe O - Ring. washer. Radiator Air. Included with: Cap, Cover, Reservoir cap.

3.6 LITER. Cap for the Hybrid Inverter Coolant Reservoir. From 12/23/2015. Inverter Cooling. Location-Reservoir. Radiator Cap. To 03/13/2017. To 05/25/2017.